AARoads Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

The AARoads Wiki is live! Come check it out!

Author Topic: Why are there columns betweeen the upper and lower bridges?  (Read 1592 times)

roadman65

  • *
  • Offline Offline

  • Posts: 15806
  • Location: Lakeland, Florida
  • Last Login: Today at 02:13:50 PM
Why are there columns betweeen the upper and lower bridges?
« on: April 17, 2023, 04:23:20 AM »

https://goo.gl/maps/PgJczSFCFcD4f8Sd6
Noticed that the upper bridge is connected to the lower bridge. Why does that need to be?
Logged
Every day is a winding road, you just got to get used to it.

Sheryl Crowe

Duke87

  • *
  • Offline Offline

  • Posts: 5955
  • Age: 36
  • Location: Stamford, CT
  • Last Login: February 28, 2024, 10:48:59 AM
Re: Why are there columns betweeen the upper and lower bridges?
« Reply #1 on: May 14, 2023, 05:36:30 PM »

The edges of the upper spans are using the spans beneath them for structural support. Notice how the lower spans have a very deep girder at the inner edge. The top span has some similarly deep girders in the middle, but a much smaller one on the edge... because the columns transfer the load down to the bridge below it instead.

I am guessing someone figured they could use a little less steel this way and thus save some money. Or at least, that would have been how it worked back when these bridges were built, since at the time the material cost of steel controlled construction cost more than labor to assemble it did, so design features that used more labor but reduced the amount of material required were common. Today, it's the other way around and newer bridges will use more material to reduce the required labor.
Logged
If you always take the same road, you will never see anything new.

 


Opinions expressed here on belong solely to the poster and do not represent or reflect the opinions or beliefs of AARoads, its creators and/or associates.