U.S. Highway 26

U.S. 26

Originating from U.S. 101 in Seaside, Oregon (retracted from Astoria in 2004), U.S. 26 overall travels east to Interstate 80 in Ogallala, Nebraska.

U.S. 26 follows State Control Route 10 from Alpine Junction to Moran Junction, State Control Route 30 from Moran Junction to Riverton, State Control Route 20 from Riverton to Shoshoni, State Control Route 34 from Shoshoni to Casper, State Control Route 505 from Casper to Glenrock, Interstate 25 from Glenrock to Dwyer Junction, and State Control Route 27 from Dwyer Junction to Nebraska (including concurrent section with State Control Route 25 [U.S. 85] near Torrington).

U.S. 26 Auxiliary Routes

In Casper, Business U.S. 26 follows the original route of U.S. 26 and the Oregon Trail before Interstate 25 was built to the north of the city. It is known as Yellowstone Highway and is cosigned with Business U.S. 20 throughout its length. Business Loop Interstate 25 and Business U.S. 87 converge with Business U.S. 20-26 on the east side of Casper's downtown, and the four routes remain merged to Interstate 25 at Eastgate.

In Douglas, it follows the Business Loop Interstate 25 route through the city; it is cosigned with Business U.S. 20 and Business U.S. 87 too.

Bypass U.S. 26 in Casper is the east-west bypass to the north of the city. The western half is cosigned Bypass U.S. 20-26, while the eastern half is signed as Interstate 25 and is signed U.S. 20-26-87. The bypass moniker is not used consistently, so don't be surprised if you see regular U.S. 20 or 26 shields without a "bypass" banner above them.

There are no primary state routes with the root x26 numbering in the state of Wyoming. Wyoming 126 is not assigned, but it would be a secondary state route in Crook County. Wyoming 226 is designated but is not signed along Missile Drive. Wyoming 326 through 926 are not assigned.

History

U.S. 26 follows the path of the historic Oregon Trail in Eastern Wyoming through Goshen County and Torrington. The Oregon Trail in Wyoming ran across the middle of the state via U.S. 30, Wyo. 28, U.S. 287, Wyo. 220, Interstate 25, and U.S. 26.

Following the North Platte River in the agrarian Goshen County, the U.S. 26 portion of the Oregon Trail is on the south bank, while the historic Mormon Trail is on the north bank. Several state parks line this corridor, including Fort Laramie State Historic Site. This was established as a trading outpost in 1834 and became a significant base for protecting the travelers along the Oregon Trail. Near the Guernsey State Park are Register Cliffs and Oregon Trail Ruts. The cliffs have inscriptions of the names of the people making the journey, while the ruts are actual wagon ruts that have carved into the soft sandstone.

The Oregon Trail continues along U.S. 26 as part of Interstate 25. There are several Oregon Trail historical sites along this portion of the road, including museums in Douglas and Glenrock. Upon reaching Casper, the trail leaves U.S. 26, heading along Wyo. 220 toward South Pass. Please go to the Wyoming 220 listing for more on the Oregon Trail.

In 1926, U.S. 26 was commissioned to begin at old U.S. 185 in Dwyer, Wyoming, and end at U.S. 30 in Ogallala, Nebraska. There was a Wyoming 26 that began at U.S. 185 in Wheatland and headed southwest to U.S. 30 at Bosler. After the great recommissioning of 1936, U.S. 26 still had the same length, but it began at the newly defined U.S. 87 rather than U.S. 185. Wyo. 26 remained as well.

It was not until 1950, nearly fifteen years later, that U.S. 26 was finally extended west to the Pacific Ocean by replacing portions of U.S. 28 in Oregon and merging with routes (mainly U.S. 20) in Idaho and Wyoming.

During that same year (1950), Wyoming 26 was recommissioned as Wyoming 34 to prevent confusion between the newly extended U.S. 26 and the state route of the same number. The routing for U.S. 26 has persisted since then, and it reached its golden anniversary in 2000.

Guide

Much of U.S. 26 overlaps with other routes. Its guide is the same as that for U.S. 89 between Alpine and Moran Junction, U.S. 287 between Moran Junction and Diversion Dam Junction, U.S. 20 between Shoshoni and Casper, and Interstate 25 between Casper and Dwyer.

The solo section of U.S. 26 between Diversion Dam junction and Riverton is best bypassed by taking Wyoming 133 and 134. This route combination goes to the north of Ocean Lake (so named because of its unusual color) and reconnects to U.S. 26 just south of Shoshoni. Riverton is a nice enough town, if not boring. Riverton boomed when uranium mining in the Gas Hills exploded; however, the closure of those mines has resulted in a downturn in Riverton. In Riverton, U.S. 26 and Wyoming 789 meet up; the two routes travel northeast toward Shoshoni along the Wind River.

At Shoshoni, U.S. 26 and U.S. 20 hook up for the long trip back to Casper. U.S. 26 then merges with Interstate 25 all the way to Dwyer Junction. Please refer to the History section, above, for information on U.S. 26 between Dwyer and the Nebraska state line. This routing parallels the historic Oregon Trail.

Photo Credits:

Connect with:

Page Updated Sunday October 30, 2005.